MATERIAL
- All animals are printed on self-adhesive, peel-and-stick waterproof vinyl.
- These stickups are designed for indoor or outdoor use on any flat, clean, dry surface.
ADHESIVE
- The stickups are removable.
- Adhesive will not remain on the wall when the stickups are removed.
APPLYING STICKUPS
Adheres to almost any smooth surface such as metal, wood, glass, cardboard, paper, plastic etc.
To apply, simply remove the backing and stick it on!
APPLICATION INSTRUCTIONS
Lay stickup face down and pull the liner off the stickup part way -- about 8 inches.
Fold the liner back on itself so the exposed back of the stickup can be applied to the wall. Remove entire backing on small stickups
Be careful not to bend or kink the stickup.
Do not allow the adhesive on the back of the stickup to contact any other area on the back of the stickup! Stickups may stretch or tear if you try to remove the backing too quickly.
After backing is removed, press exposed stickup to surface. Slowly pull the backing off the stickup and push the stickup on the wall as you pull the backing.
Finish by softly rubbing the entire stickup with a soft cloth, making sure to include all edges. If, after completion, you are unhappy with the positioning, simply remove and stick again. If the stickup does not stick well or curls at the edges, follow the instructions below.
If there are air bubbles, take a pin and poke a hole through the bubble and press. If you find the stickup pulls off the paint, you can release the stickup by squirting lighter fluid on the wall above the sticker. The lighter fluid will run down the wall and soften the adhesive. The lighter fluid will evaporate off the wall in a few minutes. Once the stickup is off, lay it face down for a few minutes and let the lighter fluid evaporate. You can then re-apply the stickup.
TO APPLY TO ROUGH OR GLOSSY SURFACES:
These stickups work best on flat walls with clean, dry flat paint. They will work on other surfaces with varying degrees of success. When you get your order, try a small stickup.
If it doesn't stick well, there is a product that can be used to increase the adhesion. This product creates a stronger bond. You can get it at Staples or other office supply stores. It is made by 3M and it is called Super77.
Put the stickup on the wall. Spray some adhesive into a paper cup. Using a small 1/2” brush, lift the edge of the stickup off the wall and paint the adhesive on the back of the stickup. Push the edge back on the wall. The stickup will stick within a few minutes as the adhesive dries. Be careful not to get Super77 on the face of the stickup.
Lighter fluid can be used to clean excess glue, but may damage the sticker. If the walls are very glossy, you can try using Hi-Strength 90 by 3M.
TO CLEAN STICKUPS:
Use a cloth or paper towel with water and wipe. Please do not use abrasives.
Product includes simple application instructions. Only apply the stickup to a clean and dry surface. The stickups are waterproof, but will be damaged by abrasion or solvents. They can be used in the shower or outdoors. They can be used on a vehicle, but there is no guarantee for this application. If being used on a vehicle, they should be coated with a clear, waterbased coating.
Please do not place a stickup within reach of a young child's crib or bed.
