Disney wall murals are prepasted, washable and dry strippable.

Each wall mural is packaged in a continuous bolt that contains 7-8 labeled panels depending on the finished width of the mural.

Each panel is alphabetically labeled in the sequence that they are to be installed starting with the left side of the mural.

Panels have a 3” bleed on the top to allow for trimming against the ceiling and a 6” bleed on the bottom for trimming against the baseboard.

Hanging Procedure for Disney Murals

Before You Begin

Carefully examine your wall mural before installing to ensure that it is the item that you ordered and that it is in good condition. If you find any defects during installation, not previously noticed, stop work immediately and notify the authorized retailer from whom you purchased the mural.

Wall Preparation

Surfaces should be clean and smooth, and primed with a premixed wallpaper sizing to ensure proper adhesion, ease of application and future removal.

If applying over vinyl wallcovering, do not wet, use a vinyl-to-vinyl adhesive.

Tools You Will Need

• Wallpaper water tray
• Wallpaper smoothing brush
• Supply of clean fresh water
• Cleaning Sponge or lint free white towels
• Pencil
• Measuring Tape
• Level or a Plumb bob
• Scissors
• Broad Knife or a Trim Guide
• Snap Off Knife and extra Blades

Hanging Procedure

Your Disney wall mural is rolled on one continuous bolt containing all the panels you need to complete your wall mural. Each panel is alphabetically labeled in the sequence that they are to be installed starting on the left side of the wall. The Winnie the Pooh wall mural contains 7 panels, Fish Are Friends, Fantasy Princess and Ballroom Princess Murals each have 8 panels.

The finished size of the Winnie the Pooh wall mural is 10’ wide by 8’ high, the Fish Are Friends, Fantasy Princess and Ballroom Princess wall murals are 12’ wide by 8’ high.

The bolt is 18 ¼” wide and each panel is 8’-6” long. The extra width and length are provided to allow for trimming and to accommodate uneven ceilings and baseboards

With a pencil (do not use ink) and a level (or a plumb bob) lightly draw a vertical line where the edge of the wall mural is to be installed. If you are starting the wall mural from a corner, draw your straight line 17¼” from the corner.

Remove the first panel from the bolt. (Panel A) Roll the strip with the prepasted side out and submerge in a water tray fill with lukewarm, clean water. (The use of additional paste, and paste activators is not necessary or recommended). Put the rolled strip in the tray so that when it is drawn from the water, the pasted side will be up.

Immediately draw the strip from the water tray by taking the end and letting the roll unwind as it is drawn out of the water. Pull the strip onto a drop cloth with the paste side up. . Do this slowly; ensuring all the paste is completely wet.

To activate the paste before installing, bring the ends of the sheet toward the center, paste side to paste side, carefully aligning the edges sot that they do not dry out. (Do Not Crease) Loosely fold the strip without creasing and allow the sheet to rest for five minutes.

Start by hanging the first strip along the plumb line that you drew earlier. Smooth the strip into position using wallpaper smoother. Using an even pressure, start in the center of the sheet and smooth out towards the edges removing all bubbles. Avoid stretching and do not overwork the edges.

Tip: If new bubbles develop after smoothing, increase the time that you are allowing for each sheet to rest.

Trim excess at the top and bottom of strip, with a snap blade knife. Refresh blade edge every 3 cuts to maintain a sharp blade, which will give you smoother cut and avoid tearing the mural. Use a trim guide or a broad knife (spackling knife) to trim against to give you a smooth edge.

Immediately clean the surface with a damp clean white cloth or an uncoloured sponge. Change water frequently to assure it is clean. Do not allow adhesive to dry on surface since some adhesives contain solvents that can adversely affect the product or turn yellow in time.

Repeat this same procedure for each panel, matching the subsequent panel to the previous panel. During hanging, match the seam at eye-level smoothing upward and downward from there. Butt seams firmly together, but do not overlap.

Recheck previously installed panels making certain that all edges are smoothed firmly to the wall and there are no large air bubbles.

Care and Maintenance

These wall murals are washable. Most common soils, grease and stains can be removed by washing with soap or a mild detergent and water. Fresh grease stains can normally be removed by wiping off immediately with an absorbent paper towel. For best results, all marks should be removed promptly.

Guarantee

These wall murals are manufactured under stringent quality control procedures, and are inspected prior to shipment. The manufacturer warrants it to be free of defects. If it is found to be defective, manufacture will replace or refund the purchase price at their discretion.